Rockford Pump Pros logo Rockford Pump Pros

2026-11-16 · Frank Ellison

Why Your Sump Pump Keeps Running and Will Not Shut Off

A sump pump that runs constantly is the single most common call we take, and it is worth understanding why it matters. A pump that cycles continuously is not protecting your basement more thoroughly. It is wearing out a motor designed to run intermittently, and in most cases it is doing so because of a fault that costs a few hundred dollars to correct. Left alone through a Rockford spring, it becomes a replacement. There are four causes behind almost every case we attend, and you can narrow it down yourself in about ten minutes.

The Check Valve Has Failed

This is the most common cause by a wide margin. The check valve sits on the vertical discharge pipe and stops water flowing back down once the pump shuts off. When it fails, the entire column of water standing in that pipe drops back into the pit the moment the pump stops, which raises the water level and triggers the float again. The pump has effectively been fooled into pumping the same water repeatedly.

The tell is a distinct clunk or gurgle a second or two after the pump switches off, followed by it starting again shortly after. If your pump runs in a short rhythmic cycle with brief pauses, and the pit never seems to drain fully, the valve is the first thing to check. It is one of the cheapest parts on the system, and replacing it is covered under float switch and motor repair.

The Float Switch Is Stuck

Rockford sits on silty clay, and fine sediment washes into the pit with every thaw. Over a few seasons it banks up around the float stem and the basin wall. A float held in the raised position tells the pump the pit is full when it is not, so the pump runs dry, which is what actually kills motors.

Unplug the pump, lift the lid and look. If the float is tethered rather than vertical, check whether it has swung against the side of the pit and jammed there, which happens constantly in the narrow pits common in Midtown and the North End. Freeing it by hand often restores normal operation immediately. If it sticks again within a week, the pit needs clearing properly, which is covered under sump pit installation and cleaning.

The Discharge Line Is Blocked or Frozen

This one is specific to our climate and it is the most expensive to ignore. From December through February, a discharge line laid too shallow will develop an ice plug at or near the outlet. The pump runs, moves water up the pipe, finds it cannot go anywhere, and the water drains back. The pump then restarts. It will do this for days until the motor fails.

The check takes thirty seconds. Go outside while the pump is running and look at the outlet. If water is not visibly leaving the pipe, unplug the pump immediately and call someone. A pump sitting idle for a few hours costs you nothing. A pump running against solid ice costs you the motor, usually in the middle of the thaw when you need it most. Prevention is covered in sump pump freeze protection for Rockford winters, and line correction under discharge and drainage repair.

The Pit Is Too Shallow

If the valve is sound, the float moves freely and water is leaving the outlet properly, the problem may be the pit itself. A pit needs enough depth to hold a working reservoir so the pump moves a meaningful volume each time it starts. Many older Rockford homes have a pit hand-cut into the slab just deep enough to take the pump body, and in those the float trips every ninety seconds during a thaw no matter how good the pump is.

This is the cause people almost never suspect, and it is why some homeowners find themselves on their third pump in ten years. Deepening the pit and fitting a properly sized sealed basin usually costs less than the next two pumps combined.

When Constant Running Is Normal

It is worth saying that a pump running frequently during a March thaw in a house near the Rock River is not necessarily faulty. If your pit genuinely refills within a minute of being emptied because the groundwater table is up, the pump is doing its job. The distinction is whether the pit actually empties between cycles. If it drains fully and then refills from real inflow, that is normal. If it never drains properly, or restarts within seconds of stopping, something is wrong.

In either case, a pump working that hard during the wet season is a strong argument for a backup. The storms that drive the water table up here are the same ones that take the power out, and a primary pump already at its limit has nothing in reserve. Battery backup systems are the usual answer for most Rockford homes.

What to Do Next

Work through it in this order: listen for the clunk that indicates a failed check valve, unplug and check the float by hand, then go outside and confirm water is actually leaving the outlet. Those three checks identify the cause in the large majority of cases, and two of the three you can confirm yourself in minutes. If the pump is running against a blocked line, unplug it first and deal with diagnosis afterwards. That one decision is often the difference between a repair and a replacement.

Need Sump Pump Repair or Installation in Rockford, IL?

Talk to a local sump pump repair and installation company serving Rockford, Loves Park and Machesney Park. Upfront quotes and workmanship you can inspect on every sump pump repair and installation.

Business hours

Mon–Fri 8am–6pm, Sat 9am–2pm

438 S Winnebago St, Rockford, IL 61102

Call now Get a quote